1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the BPS at idle and IG ON.
Pressure [kPa (kgf/cm², psi)] Output Voltage (V) [Ref=5V] 10.0 (0.01, 0.15) 0.50 55.0 (0.56, 7.98) 2.21 115.0 (1.17, 16.9) 4.50
1.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Disconnect the barometric pressure sensor connector (A).
3.
Remove the mounting bolt (B) and then remove the sensor from the air cleaner assembly.
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Insert the sensor in the installation hole and be careful not to damage sensor when installing.
1.
Install in the reverse order of removal.
Barometric pressure sensor mounting bolt:
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
Specification
Pressure [kPa (kgf/cm², psi)]Output Voltage (V) [Ref=5V]20.0 (0.20, 2.90)0.7946.66 (0.47, 6.77)1.84101.32 (1.03, 14.7)4.0
...
Other Information: Engine number
Brake Booster Repair procedures
Kia Sedona: Barometric Pressure Sensor (BPS) Repair procedures
Barometric Pressure Sensor (BPS) Schematic Diagrams
Manifold Absolute Pressure Sensor (MAPS) Specifications