Kia Sedona: Manifold Absolute Pressure Sensor (MAPS) Specifications

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Engine Control System / Manifold Absolute Pressure Sensor (MAPS) Specifications

Barometric Pressure Sensor (BPS) Repair procedures

Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the BPS at idle and IG ON. Pressure [kPa (kgf/cm², psi)]Output Voltage (V) [Ref=5V]10.0 (0. ...

Manifold Absolute Pressure Sensor (MAPS) Description and Operation

Description Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog si ...

Other Information:

Limitation of Active ECO operation
If the following conditions occur while Active ECO is operating, the system operation is limited even though there is no change in the ECO indicator. When the coolant temperature is low: The sys ...

Inhibitor Switch Repair procedures
Inspection Power Circuit Inspection 1. Disconnect the Inhibitor switch connector. 2. Ignition KEY "ON"" & Engine "OFF".. 3. Measure voltage between supplied power and ground at inhi ...