Kia Sedona: 35R Clutch Control Solenoid Valve(35R/C_VFS) Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sedona YP Service ManualKia Sedona: 35R Clutch Control Solenoid Valve(35R/C_VFS) Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / 35R Clutch Control Solenoid Valve(35R/C_VFS) Repair procedures

Inspection
1.
Turn ignition switch OFF.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the solenoid valve connector (A).

4.
Measure the resistance between power terminal (10) and signal terminal (6).

Specification : 5.1 ± 0.3 Ω

Replacement
   
If a solenoid valve of VFS type needs to be replaced, the valve body assembly should be replaced and the oil pressure should be adjusted. If the solenoid valve is replaced individually, it is not possible to adjust the oil pressure without additional equipment, and if the oil pressure adjustment procedure is not performed, a shift shock or delay may occur.
1.
Replace the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
35R Clutch Control Solenoid Valve(35R/C_VFS) Schematic Diagrams
Circuit Diagram ...

26 Brake Control Solenoid Valve(26/B_VFS) Specifications
Specification Item SpecificationControl typeN/L (Normal Low)Control pressure kpa(kgf/cm², psi)"9.81 ~ 500.14(0.1 ~ 5.1, 1.42 ~ 72.54)"Current value (mA)50 ~ 850Coil resistance(Ω)5.1 ± 0.3 ...

Other Information:

A/V Mode
This mode displays the state of the A/V system. ...

Power sliding door operation
Push the corresponding main control button on the overhead console to open or close the power sliding door. However, the power sliding door will not open with the main control button when ...

Categories

Copyright © www.kisedona.com 2016-2026