Kia Sedona: Injector Drive Box (IDB) Repair procedures - Engine Control System - Engine Control / Fuel System - Kia Sedona YP Service ManualKia Sedona: Injector Drive Box (IDB) Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Engine Control System / Injector Drive Box (IDB) Repair procedures

Removal
1.
Turn the ignition switch off and disconnect the battery negative (-) Terminal.
2.
Remove the mounting nuts (A) and disconnect the connector (B), and then remove the injector drive box.

Installation
1.
Install in the reverse order of removal.

IDB mounting nut:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Injector Drive Box (IDB) Schematic Diagrams
IDB terminal and In/Output IDB terminal function Connector [E09] Pin No.DescriptionConnected to1- 2- 3- 4- 5- 6- 7- 8- 9- 10- 11- 12- 13- 14- 15- 16Injector (Cyl ...

ETC (Electronic Throttle Control) System Specifications
Specification [Throttle Position Sensor (TPS)] Throttle angle(°)Output Voltage (V) [Ref=5V]TPS1TPS200.54.5100.964.05201.413.59301.873.14402.322.68502.782.23603.231.77703.691.32804.140.86904.60. ...

Other Information:

Water Jacket Seperator Components and Components Location
Components 1. Water jacket separator ...

For power sliding door
1. Put the shift lever in the P (Park). 2. Close the fuel filler lid. 3. Change the position of fuse switch to OFF on the driver's side fuse panel and change the position of fuse switch to ON ...

Categories

Copyright © www.kisedona.com 2016-2026