Kia Sedona: Smart Cruise Control Switch Repair procedures| Inspection |
| Measuring Resistance |
| 1. |
Disconnect the cruise control switch connector from the control switch. |
| 2. |
Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed).
|
| 3. |
If not within specification, replace switch.
|
| Measuring Voltage |
| 1. |
Connect the cruise control switch connector to the control switch. |
| 2. |
Measure voltage between terminals on the harness side connector when each function switch is ON (switch is depressed).
|
| 3. |
If not within specification, inspect the control switch resistance. |
| Removal |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery terminal. |
| 2. |
Remove the air-bag module from the steering wheel.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring") |
| 3. |
Release the remote control switch (A) after loosening the screws.
|
| 4. |
Disconnect the remote control switch connector (A).
|
| Installation |
| 1. |
Install in the reverse order of removal. |
Smart Cruise Control Switch Schematic Diagrams
Starting SystemFolding the outside rearview mirror
Electric type
The outside rearview mirror can be folded or unfolded by pressing the switch
when the ignition switch is ACC or ON position as below.
Left (1) : The mirror will unfold.
Right (2) ...
Rear mode selection
Front climate control is :
Rear air blows from the upper vents on the rear ceiling.
Front climate control is :
Rear air blows from the upper vents on the rear ceiling and the lower vents
...