Kia Sedona: Turn Signal Lamp Repair procedures - Lighting System - Body Electrical System - Kia Sedona YP Service ManualKia Sedona: Turn Signal Lamp Repair procedures

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Body Electrical System / Lighting System / Turn Signal Lamp Repair procedures

Removal
Door Mirror Turn Signal Lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the mirror (A) from the mirror holder.

   
Be careful not to damage the fixing clip

3.
Disconnect the heating connector (A) from the mirror.

4.
Remove the door mirror housing (B) after separating the mounting clips (A).

5.
Remove the door mirror turn signal lamp (A) after loosening the screw.

6.
Disconnect the connector (A) from the door mirror turn signal lamp.

Installation
Door Mirror Turn Signal Lamp
1.
Install the door mirror turn signal lamp.
2.
Install the door mirror housing.
3.
Install the door mirror.
4.
Connect the negative (-) battery terminal.
Head Lamps Repair procedures
Removal     Head lamps become very hot during use; do not touch them or attach any hardware immediately after turning them off.     • T ...

Room Lamp Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Detach the lamp lens (A) from the room lamp with a flat-tip screwdriver. 3. Remove the room lamp (A) after loosening the screws. ...

Other Information:

Troubleshooting
Failure Check-up Elements The following is to be checked before inspecting the Power Sliding Door system parts. 1. Manual operation Check if the sliding door operates manually. Shift to ''OFF'' ...

Resetting the sunroof
Whenever the vehicle battery is disconnected or discharged, you must reset your sunroof system as follows: 1. Turn the ignition switch to the ON position. 2. Close the sunshade and sunroof complet ...

Categories


Copyright В© www.kisedona.com 2016-2025