Kia Optima Manuals

Kia Sedona: Receiver-Drier Repair procedures - Air conditioning System - Heating,Ventilation And Air Conditioning - Kia Sedona YP Service ManualKia Sedona: Receiver-Drier Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Receiver-Drier Repair procedures

Replacement
1.
Remove the condenser.
2.
Remove the cap (B) on the bottom of the condenser with an L wrench (A).
Tightening torque :
9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)

3.
Remove the receiver-drier (A) from condenser using a long nose plier. Check for crumbled receiver-drier and clogged bottom cap filter.

4.
Apply air conditioning compressor oil along the O-rings and threads of the new bottom cap.
5.
Insert a new receiver-drier into the receiver drier tank. The receiver-drier must be sealed in vacuum before it is exposed to air for use.
6.
Install a new bottom cap to the condenser.
   
•
Always replace the receiver-drier and bottom cap at the same time.
•
Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right O-rings for R-134a to avoid leakage.
•
Be careful not to damage the radiator and condenser fins when installing the condenser.
•
Charge the system, and test its performance.
Condenser Repair procedures
Inspection 1. Check the condenser fins for clogging and damage. If clogged, clean them with water, and blow them with compressed air. If bent, gently bend them using a screwdriver or pliers. ...

A/C Pressure Transducer Description and Operation
Description The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the coolin ...

Other Information:

Shift Cable Repair procedures
Removal 1. Move the shift lever to "N" range. 2. Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner) 3. Remove the battery and battery tray. (Refer to Eng ...

LCD Display Control
Type A The LCD display modes can be changed by using the control buttons on the steering wheel. [Type A] (1) ▲ / ▼ : TRIP scroll switch for changing trip modes (2) RESET : RESET bu ...

Categories

Copyright © www.kisedona.com 2016-2026