The A/C Pressure Transducer (APT) converts the pressure value
of high pressure line into voltage value after measuring it. By
converted voltage value, engine ECU controls the cooling fan by
operating it at high speed or low speed. Engine ECU stops the operation
of the compressor when the temperature of refrigerant line is very high
or very low irregularly to optimize air conditioning system.
Replacement
1.
Remove the condenser.
2.
Remove the cap (B) on the bottom of the condenser with an L wrench (A).
Tightening torque :
9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)
...
Inspection
1.
Measure the pressure of high pressure line by measuring voltage output between terminals “1” and “2”.
2.
Inspect the voltage value to determine whether it is within speci ...
Other Information:
Repair procedures
Adjustment
1.
After loosening the tail gate hinge (A) mounting bolt, adjust the tail gate by moving it up and down, or right and left.
2.
Adjust the tail gate height by turning the tail gate o ...
ETC (Electronic Throttle Control) System Specifications
Specification
[Throttle Position Sensor (TPS)]
Throttle angle(°)Output Voltage (V) [Ref=5V]TPS1TPS200.54.5100.964.05201.413.59301.873.14402.322.68502.782.23603.231.77703.691.32804.140.86904.60. ...