Operates as follows when the ignition switch is turned ON.
MIST : For a single wiping cycle, move the lever to this (MIST/)
position and release it. The wipers will operate continuously if the lever is held
in this position.
OFF : Wiper is not in operation
INT : Wiper operates intermittently at the same wiping intervals. Use this mode in light rain or mist. To vary the speed setting, turn the speed control knob.
LO : Normal wiper speed
HI : Fast wiper speed
✽ NOTICE
If there is heavy accumulation of snow or ice on the windshield, defrost the windshield for about 10 minutes, or until the snow and/or ice is removed before using the windshield wipers to ensure proper operation.
Repair procedures
Replacement
1.
Remove the cap (A), the nuts and the wiper arm (B).
Tightening torque :
22.6 ~ 26.5 N.m(2.3 ~ 2.7 kgf.m, 16.6 ~ 19.5 lb-ft)
2.
Disconnect the cowl top cover nozzle hose (A ...
Emergency starting
Connect cables in numerical order and disconnect in reverse order. ...