Kia Sedona: Wheel Repair procedures - Tires/Wheels - Suspension System - Kia Sedona YP Service ManualKia Sedona: Wheel Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Suspension System / Tires/Wheels / Wheel Repair procedures

Hub nut tightening sequence
Tighten the hub nuts as follows.

Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

   
When using an impact gun, final tightening torque should be checked using a torque wrench.
Run out inspection
1.
Jack up the vehicle.
2.
Measure the wheel Run-out by using a dial indicator as in the illustration below.
Run-out
Aluminum
Aluminum
Radial mm(in.)
0.3(0.0118)
0.7(0.028)
Lateral mm(in.)
0.3(0.0118)
1.1(0.043)

3.
If measured value exceeds the standard value, replace the wheel.

Tire Repair procedures
Tire Wear     • Using tires and wheels of other than the recommended sizes can cause unusual handling characteristics and poor vehicle control, resulting in a ...

Tire Pressure Monitoring System
...

Other Information:

Seat Heater Switch Components and Components Location
Components 1. Driver seat heater switch2. Assist seat heater switch 1. Second row seat heater switch [LH]2. Second row seat heater switch [RH] ...

Tire pressure
Always observe the following: Check tire pressure when the tires are cold. (After vehicle has been parked for at least three hours or hasn't been driven more than 1.6 km (one mile) since ...

Categories

Copyright © www.kisedona.com 2016-2026