Kia Sedona: Water Jacket Seperator Repair procedures - Cylinder Block - Engine Mechanical System - Kia Sedona YP Service ManualKia Sedona: Water Jacket Seperator Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Mechanical System / Cylinder Block / Water Jacket Seperator Repair procedures

Removal
1.
Remove the LH/RH cylinder head assembly and gasket.
(Refer to Cylinder Head Assembly - "Cylinder Head")
2.
Remove the water jacket seperators (A).

Installation
1.
Install the #1, #2 cylinder bore water jacket seperators (A).

   
Insert the separator align into the block inner side protrusion making sure that it is located below the cylinder head installing surface.

2.
Install the LH/RH cylinder head assembly and gasket.
(Refer to Cylinder Head Assembly - "Cylinder Head")
Water Jacket Seperator Components and Components Location
Components 1. Water jacket separator ...

Drive Plate Components and Components Location
Components 1. Drive plate2. Adapter plate ...

Other Information:

Don
Under some conditions your parking brake can freeze in the engaged position. This is most likely to happen when there is an accumulation of snow or ice around or near the rear brakes or if the bra ...

OFF mode
Press the front blower OFF button to turn off the front air climate control system. However, you can still operate the mode and air intake buttons as long as the ignition switch is in the ON pos ...

Categories

Copyright © www.kisedona.com 2016-2026