Kia Sedona: Starter Relay Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Electrical System / Starting System / Starter Relay Repair procedures

Inspection

1.	Turn ignition switch OFF and disconnect the negative (-) battery terminal.

2.	Remove the fuse box cover.

3.	Remove the starter relay (A).

Check for continuity between the terminals (30 and 87) using an ohmmeter.

Terminal	Resistance	Measure
30 - 87	1MΩ or higher	If there is continuity between the terminals, replace the relay.

Apply 12V to the terminal 85 and ground to the terminal 86 and then check for continuity between the terminals (30 and 87).

Terminal	Resistance	Measure
30 - 87	1Ω or less	If there is no continuity between the terminals, replace the relay.

6.	Install the starter relay.

7.	Install the fuse box cover.

Starter Repair procedures

Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2. Remove the engine room under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover" ...

Other Information:

Don't neglect the interior
Moisture can collect under the floor mats and carpeting and cause corrosion. Check under the mats periodically to be sure the carpeting is dry. Use particular care if you carry fertilizers, cleani ...

Non-operational conditions of rear parking assist system
The rear parking assist system may not operate properly when : 1. Moisture is frozen to the sensor. (It will operate normally when the moisture has been cleared.) 2. The sensor is covered with for ...

Kia Sedona: Starter Relay Repair procedures

Starter Repair procedures

Emission Control System

Other Information:

Categories