The rear parking assist system may not operate properly when :
1. Moisture is frozen to the sensor. (It will operate normally when the moisture has been cleared.)
2. The sensor is covered with foreign matter, such as snow or water, or the sensor cover is blocked. (It will operate normally when the material is removed or the sensor is no longer blocked.)
3. Driving on uneven road surfaces (unpaved roads, gravel, bumps, gradient).
4. Objects generating excessive noise (vehicle horns, loud motorcycle engines, or truck air brakes) are within range of the sensor.
5. Heavy rain or water spray exists.
6. Wireless transmitters or mobile phones are within range of the sensor.
7. The sensor is covered with snow.
8. Trailer towing
The detecting range may decrease when :
1. The sensor is stained with foreign matter such as snow or water. (The sensing range will return to normal when removed.)
2. Outside air temperature is extremely hot or cold.
The following objects may not be recognized by the sensor :
1. Sharp or slim objects such as ropes, chains or small poles.
2. Objects which tend to absorb the sensor frequency such as clothes, spongy material or snow.
3. Undetectable objects smaller than 1 m (40 in.) in height and narrower than 14 cm (6 in.) in diameter.
To resume cruising speed at more than approximately 30 km/h (20 mph)
If any method other than the CRUISE ON-OFF switch was used to cancel cruising
speed and the system is still activated, the most recent set speed will automatically
resume when you move the lever ...
Seat Belt Pretensioner (BPT) Repair procedures
Removal
1.
Disconnect the battery negative cable, and wait for at least 30 seconds before beginning to work.
2.
Left side - Remove the seat belt lower anchor cover (A).
After loosening the ...