Kia Optima Manuals

Kia Sedona: Accelerator Position Sensor (APS) Repair procedures - Engine Control System - Engine Control / Fuel System - Kia Sedona YP Service ManualKia Sedona: Accelerator Position Sensor (APS) Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Engine Control System / Accelerator Position Sensor (APS) Repair procedures

Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
Accelerator
Position
Output Voltage (V) [Ref=5V]
APS1
APS2
C.T
0.7 ~ 0.8
0.29 ~ 0.46
W.O.T
3.85 ~ 4.35
1.93 ~ 2.18

Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
2.
Disconnect the accelerator position sensor connector (A).
3.
Remove the installation nuts (B) and then remove the accelerator pedal module.

Installation
1.
Install in the reverse order of removal.
Accelerator pedal module mounting nut:
12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)
Accelerator Position Sensor (APS) Schematic Diagrams
Circuit Diagram ...

Fuel Tank Pressure Sensor (FTPS) Specifications
Specification ItemSpecificationSupply Voltage (V)5Operation Voltage (V)4.75 ~ 5.25 Pressure [kPa (kgf/cm², psi)]Output Voltage (V) [Ref=5V]-6.67 (-0.06, -0.97)0.502.5+6.67 (0.068, 0.97)4.5 ...

Other Information:

Hood Latch Repair procedures
Replacement 1. Loosen the fastener and remove the front bumper upper cover (A). 2. Remove the hood lower latch assembly (A) mounting bolts. Tightening torque : 7.8 ~ 11.8N.m (0.8 ~ 1.2kgf. ...

Rear Seat Back Cover Repair procedures
Replacement [Second row seat assembly] [7Seat/8Seat]     When reclining or returning the second-row seat in upright position, secure enough space in front and back of t ...

Categories

Copyright © www.kisedona.com 2016-2026