Kia Sedona: Barometric Pressure Sensor (BPS) Repair procedures| Inspection |
| 1. |
Connect the GDS on the Data Link Connector (DLC). |
| 2. |
Measure the output voltage of the BPS at idle and IG ON.
|
| Removal |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
| 2. |
Disconnect the barometric pressure sensor connector (A). |
| 3. |
Remove the mounting bolt (B) and then remove the sensor from the air cleaner assembly.
|
| Installation |
|
| 1. |
Install in the reverse order of removal.
|
Barometric Pressure Sensor (BPS) Schematic Diagrams
Manifold Absolute Pressure Sensor (MAPS) SpecificationsRepair procedures
Fuel Pressure Test (Low pressure system)
1.
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line").
...
Portable lamp usage
1. In-vehicle lamp, if necessary, after separation can be used as a portable.
2. Press push button (1).
3. Pull out the lamp holder.
4. Press the power switch (2).
❈ If the portable lamp ...