Kia Optima Manuals

Kia Sedona: Ignition Coil Repair procedures - Ignition System - Engine Electrical System - Kia Sedona YP Service ManualKia Sedona: Ignition Coil Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Electrical System / Ignition System / Ignition Coil Repair procedures

Removal
Ignition coil (Cylinder #1) [Bank 1]
1.
Remove the surge tank.
(Refer to Engine Mechanical System - "Surge Tank")
2.
Disconnect the Ignition coil connector (A).
3.
Remove the ignition coil after loosening the mounting bolt (B).

Ignition coil (Cylinder #2) [Bank 2]
1.
Turn the ignition switch off and disconnect the battery negative (-) Terminal.
2.
Disconnect the Ignition coil connector (A).
3.
Remove the ignition coil after loosening the mounting bolt (B).

Ignition coil (Cylinder #3) [Bank 1]
1.
Remove the surge tank.
(Refer to Engine Mechanical System - "Surge Tank")
2.
Disconnect the Ignition coil connector (A).
3.
Remove the ignition coil after loosening the mounting bolt (B).

Ignition coil (Cylinder #4) [Bank 2]
1.
Turn the ignition switch off and disconnect the battery negative (-) Terminal.
2.
Disconnect the Ignition coil connector (A).
3.
Remove the ignition coil after loosening the mounting bolt (B).

Ignition coil (Cylinder #5) [Bank 1]
1.
Remove the surge tank.
(Refer to Engine Mechanical System - "Surge Tank")
2.
Disconnect the Ignition coil connector (A).
3.
Remove the ignition coil after loosening the mounting bolt (B).

Ignition coil (Cylinder #6) [Bank 2]
1.
Turn the ignition switch off and disconnect the battery negative (-) Terminal.
2.
Disconnect the Ignition coil connector (A).
3.
Remove the ignition coil after loosening the mounting bolt (B).

   
•
When removing the ignition coil connector, pull the lock pin (A) and push the clip (B).

Installation
1.
Install in the reverse order of removal.
Ignition coil mounting bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft)
Inspection
1.
Remove the ignition coil.
(Refer to "Removal")
2.
Measure the primary coil resistance between terminals (+) and (-).

Standard value: 0.62Ω ± 10%
Ignition Coil Schematic Diagrams
Circuit Diagram ...

Spark Plug Specifications
Specification ItemSpecificationTypeSILZKR7B11Gap1.0 ~ 1.1 mm(0.0394 ~ 0.0433 in.)Insulation resistance (MΩ)10 or more ...

Other Information:

Rear Seat Belt Retractor Repair procedures
Replacement [Second row seat belt retractor]     When installing the belt, make sure not to damage the retractor. 1. Remove the rear pillar trim. (Refer to Interi ...

Front Disc Brake Repair procedures
Removal 1. Remove the front wheel & tire. Tightening torque: 88.3 ~107.9 N.m (9.0 ~11.0 kgf.m, 65.1 ~79.6 lb-ft) 2. Loosen the hose eyebolt (B) and caliper mounting bolts (C), and t ...

Categories

Copyright © www.kisedona.com 2016-2026