Kia Optima Manuals

Kia Sedona: Cooling Fan Repair procedures - Cooling System - Engine Mechanical System - Kia Sedona YP Service ManualKia Sedona: Cooling Fan Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Mechanical System / Cooling System / Cooling Fan Repair procedures

Removal and Installation
1.
Disconnect the battery negative terminal.
2.
Remove the air duct (A).

3.
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover")
4.
Disconnect the hood latch cable (A).

5.
Disconnect the horn connector (A) and hood latch connector (B).

6.
Remove the radiator upper member assembly (A).
Tightening torque :
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

7.
Separate the radiator upper hose (A) from the hose fixing bracket (B).

8.
Disconnect the cooling fan connector.

9.
Remove the cooling fan mounting bolt.
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
[LH]

[RH]

10.
Remove the cooling fan assembly (A) from the vehicle.

11.
Install in the reverse order of removal.
Resistor
1.
Disconnect the wire harness connector (A) and the fan motor connector (B).

2.
Remove the resistor (A) from the cooling fan shroud.
Tightening torque :
1.8 ~ 2.4 N.m (0.18 ~ 0.25 kgf.m, 1.3 ~ 1.8 lb-ft)

3.
Install in the reverse order of removal.
Disassembly
1.
Remove the cooling fan (A) from the cooling fan assembly.
Tightening torque :
2.8 ~ 3.2 N.m (0.29 ~ 0.33 kgf.m, 2.1 ~ 2.4 lb-ft)

2.
Disconnect the fan motor connector (A) from the resistor.

3.
Remove the fan motor (A) from the cooling fan shroud.
Tightening torque :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.4 lb-ft)

4.
Install in the reverse order of removal.
Cooling Fan Schematic Diagrams
Circuit Diagram ...

Radiator Components and Components Location
Components 1. Radiator2. Radiator lower mounting insulator3. Radiator upper mounting bracket (LH)4. Radiator upper mounting bracket (RH)5. Radiator upper hose6. Radiator lower hose7. Radiator c ...

Other Information:

Repair procedures
On-vehicle Inspection Inspect ignition coil assembly and Perform spark test 1. Check for DTCs.     • If a DTC is present, perform troubleshooting in accordanc ...

Fuel Tank Pressure Sensor (FTPS) Description and Operation
Description Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge con ...

Categories

Copyright © www.kisedona.com 2016-2026