Kia Sedona: General Information

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / General Information / Lift And Support Points / General Information

Lift And Support Points

When heavy rear components such as suspension, fuel tank, spare tire, tailgate and trunk lid are to be removed, place additional weight in the luggage area before hoisting. When substantial weight is removed from the rear of the vehicle, the center of gravity may change and can cause the vehicle to tip forward on the hoist.

•	Since each tire/wheel assembly weights approximately 14kg (30lbs), placing the front wheels in the luggage area can assist with the weight distribution.

•	Use the same support points to support the vehicle on safety stands.

1.	Place the lift blocks under the support points as shown in the illustration.

2.	Raise the hoist a few inches (centimeters) and rock the vehicle to be sure it is firmly supported.

3.	Raise the hoist to full height to inspect the lift points for secure support.

Lift And Support Points

...

Towing

...

Other Information:

Ambient Temperature Sensor Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Remove the front bumper. (Refer to Body - "Front Bumper Cover") 3. Disconnect ambient temperature sensor. 4. Check the resistance of the ...

Heater & A/C Control Unit (Manual) Components and Components Location
Component Connector Pin Function Connector Pin NoFunctionConnector Pin NoFunctionA1COMMONB18-2GND19ILL- (RHEO)3HIGH20GND4LOW21IGN 25MIDDLE LOW22ECV+6MIDDLE HIGH23ECV-(GND)B1BATT24-2I ...

Kia Sedona: General Information

Lift And Support Points

Towing

Other Information:

Categories