Kia Sedona: If the engine does not start - What to do in an emergency - Kia Sedona YP Owners ManualKia Sedona: If the engine does not start

Third generation YP (2014-2024) / Kia Sedona YP Owners Manual / What to do in an emergency / If the engine does not start

If engine doesn't turn over or turns over slowly

1.If your vehicle has an automatic transaxle, be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake is set.

2.Check the battery connections to be sure they are clean and tight.

3.Turn on the interior light. If the light dims or goes out when you operate the starter, the battery is discharged.

4.Check the starter connections to be sure they are securely tightened.

5.Do not push or pull the vehicle to start it. See instructions for "Jump starting".

WARNING - Push/ pull start

If the engine will not start, do not push or pull the vehicle to start it. This could result in a collision or cause other damage. In addition, push or pull starting may cause the catalytic converter to overload and create a fire hazard.

If engine turns over normally but does not start

1.Check the fuel level.

2.With the ignition switch in the LOCK position, check all connectors at the ignition coils and spark plugs. Reconnect any that may be disconnected or loose.

3.Check the fuel line in the engine compartment.

4.If the engine still does not start, call an authorized Kia dealer or seek other qualified assistance.

In case of an emergency while driving
If the engine stalls at a crossroad or crossing If the engine stalls at a crossroad or crossing, set the shift lever in the N (Neutral) position and then push the vehicle to a safe place. If you h ...

Emergency starting
Connect cables in numerical order and disconnect in reverse order. ...

Other Information:

Vehicle weight glossary
This section will guide you in the proper loading of your vehicle and/or trailer, to keep your loaded vehicle weight within its design rating capability, with or without a trailer. Properly loadin ...

Injector Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance between the injector terminals 1 and 2. 4. Check that the resistance is within t ...

Categories


Copyright В© www.kisedona.com 2016-2024