Kia Sedona: Removal and reinstallation - Headrest (for front seat) - Seats - Safety features of your vehicle - Kia Sedona YP Owners ManualKia Sedona: Removal and reinstallation

Third generation YP (2014-2024) / Kia Sedona YP Owners Manual / Safety features of your vehicle / Seats / Headrest (for front seat) / Removal and reinstallation

Type A

Type B

To remove the headrest :

1. Recline the seatback (2) with the recline lever or switch (1).

2. Raise headrest as far as it can go.

3. Press the headrest release button (3) while pulling the headrest up (4).

WARNING

NEVER allow anyone to ride in a seat with the headrest removed.

Type A

Type B

To reinstall the headrest :

1. Put the headrest poles (2) into the holes while pressing the release button (1).

2. Recline the seatback (4) with the recline lever or switch (3).

3. Adjust the headrest to the appropriate height.

WARNING - Headrest Reinstallation

To reduce the risk of injury to the head or neck, always make sure the headrest is locked into position and adjusted properly after reinstalling.

Adjusting the height up and down
To raise the headrest, pull it up to the desired position (1). To lower the headrest, push and hold the release button (2) on the headrest support and lower the headrest to the desired position ...

Seatback pocket
The seatback pocket is provided on the back of the front passenger ...

Other Information:

Cowl Cross Bar Assembly Repair procedures
Replacement     Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, an ...

Mode Control Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when 12V is connected t ...

Categories


Copyright В© www.kisedona.com 2016-2024