Kia Sedona: Heater & A/C Control Unit (Rear) Repair procedures - Controller - Heating,Ventilation And Air Conditioning - Kia Sedona YP Service ManualKia Sedona: Heater & A/C Control Unit (Rear) Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Controller / Heater & A/C Control Unit (Rear) Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Using a screwdriver or ornament remover, remove the rear heater & A/C controller (A).

2.
Disconnect the rear heater & A/C controller connector (A).

3.
Install in the reverse order of removal.
   
Make sure that the connectors are plugged in properly.
Heater & A/C Control Unit (Rear) Components and Components Location
Components (1) [Standard] Connector Pin Function Connector Pin NoFunctionA1BATT2ILL+ (TAIL)3MODE ACT''R F/B - REAR4MODE ACT''R (VENT) - REAR5MODE ACT''R (FLOOR) - REAR6TEMP ACT''R F/B - ...

Other Information:

Gross vehicle weight
...

3 Point rear center belt (for 2nd and/ 3rd center seat)
To fasten the rear center belt 1. Pull out the mini tongue from hole on the belt assembly cover (1) and then slowly pull the seat belt out from the retractor. 2. Pull out the tongue plate from ...

Categories

Copyright © www.kisedona.com 2016-2026