Kia Sedona: Blower Unit Components and Components Location - Blower - Heating,Ventilation And Air Conditioning - Kia Sedona YP Service ManualKia Sedona: Blower Unit Components and Components Location

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Blower / Blower Unit Components and Components Location

Components Location

1. Blower Unit

Components

1. Inlet Seal
2. Intake Actuator
3. Antinoise Pad
4. Blower Upper Case
5. Blower Lower Case
6. Blower Motor
7. Inlet Duct Upper Case
8. Inlet Door Assembly
9. Inlet Duct Lower Case
10. Air Filter
11. Air Filter Cover
12. Cluster Ionizer
13. FET Assembly
14. Blower resistor (Manual)

Blower
...

Blower Unit Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/recycling/charging station. 3. When the engine is cool, drain the engine coolant fro ...

Other Information:

Water Temperature Control Assembly Components and Components Location
Components 1. Water pipe 2. Throttle body coolant hose & pipe3. Water temperature control assembly4. O-ring ...

Automatic turn off function
The interior lights automatically turn off approximately 20 minutes after the ignition switch is turned off, if the lights are in the ON position. If your vehicle is equipped with the theft alarm s ...

Categories

Copyright © www.kisedona.com 2016-2026