Kia Optima Manuals

Kia Sedona: Ambient Temperature Sensor Repair procedures - Air conditioning System - Heating,Ventilation And Air Conditioning - Kia Sedona YP Service ManualKia Sedona: Ambient Temperature Sensor Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Ambient Temperature Sensor Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Remove the front bumper.
(Refer to Body - "Front Bumper Cover")
3.
Disconnect ambient temperature sensor.
4.
Check the resistance of the ambient temperature sensor between terminals 1 and 2 whether it changes by changing the ambient temperature.

Specification
Ambient temperature [°C(°F)]
 Resistance between terminals 1 and 2 (kΩ)
-10(14)
158.18
0 (32)
95.10
10 (50)
58.80
20 (68)
37.32

5.
If the measured resistance is not within specification, substitute with a known-good ambient temperature sensor and check for proper operation.
6.
Replace the ambient temperature sensor if it is proved that there is a problem with the sensor.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front bumper.
(Refer to Body - "Front Bumper")
3.
Disconnect the connector (A) and then remove the ambient temperature sensor (B).

4.
Install in the reverse order of removal.
Ambient Temperature Sensor Description and Operation
Description The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower te ...

Auto Defogging Sensor (DATC only) Description and Operation
Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal to blow out wind for defogging if moisture occurs. On receiving the signal from ...

Other Information:

Components and Components Location
Components 1. Drive belt (with HPS)2. Drive belt (with MDPS)3. Drive belt tensioner4. Idler5. Crankshaft damper pulley6. Water pump pulley 1. Timing chain cover2. Oil pump chain cover3. Oil ...

Drive Plate Repair procedures
Removal and Installation 1. Remove the automatic transaxle. (Refer to Automatic Transaxle System - "Automatic Transaxle") 2. Remove the adapter plate (A) and the drive plate (B). Tighten ...

Categories

Copyright © www.kisedona.com 2016-2026