Kia Optima Manuals

Kia Sedona: Power Door Mirror Actuator Repair procedures - Power Door Mirrors - Body Electrical System - Kia Sedona YP Service ManualKia Sedona: Power Door Mirror Actuator Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Power Door Mirrors / Power Door Mirror Actuator Repair procedures

Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door quadrant inner cover (A).

3.
Disconnect the power door mirror connector from the harness.

4.
Apply battery voltage to each terminal as shown in the table and verify that the mirror operates properly.
[Actuator]

[Mirror Control (LH/RT)]

[Puddle Lamp]

[BSD Indicator]

[Mirror Heater]

[Side repeater Lamp]

[Folding Mirror]

Diagnosis With GDS
1.
The body electrical system can be quickly diagnosed for faulty parts using vehicle diagnostic system (GDS).
The diagnostic system (GDS) provides the following information:
(1)
Self diagnosis : Checking the failure code (DTC) and display
(2)
Current data : Checking the system input/output data state
(3)
Actuation test : Checking the system operation condition
(4)
Additional function : Other controlling such as he system option and zero point
2.
Select the ''Car model'' and the system to be checked in order to check the vehicle with the tester.
3.
Select the ''Body Control Module (BCM)'' to check the driver seat or assistant door module (DDM/ADM).
4.
Select the "Current Data" menu to search the current state of the input/output data.
The input/output data for the sensors corresponding to the driver seat or assistant door module(DDM/ADM) can be checked.

5.
If you wish to check the power door lock operation by force, select "Actuation test".
Power Door Mirror Switch Repair procedures
Inspection [Power Mirror Switch (Non-IMS] 1. Disconnect the negative (-) battery terminal. 2. Remove the front left door trim. (Refer to Body - "Front Door Trim") 3. Disconnect the power ...

Power Sliding Door System
...

Other Information:

High beam assist indicator
This warning light illuminates : When the high-Beam is on with the light switch in the AUTO light position. If your vehicle detects oncoming or preceding vehicles, the High beam assist syst ...

Front Stabilizer Bar Repair procedures
Removal 1. Loosen the bolt (A) and then disconnect the universal joint assembly from the pinion of the steering gear box. Tightening torque: 32.4 ~ 37.3N.m (3.3 ~ 3.8kgf.m, 23.9 ~ 27.5lb-ft) ...

Categories

Copyright © www.kisedona.com 2016-2026