Kia Sedona: Auto Head lamp leveling Unit Description and Operation

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Head lamp leveling Device / Auto Head lamp leveling Unit Description and Operation

Description

According to driving environment and loading state of vehicle, head lamp lighting direction is changed to keep the driver''s visibility range and to protect the driver''s vision from glare, aiming at safety driving.

Sensor integrated into ECU mounted on the rear center arm drives the actuator mounted on the head lamp by sensing the input signal in case of vehicle static change.

Head lamp beam is automatically operated by chassis tilt.

Operation

Operating Procedure

1.	Suspension angle changes due to change in vehicle load.

2.	Sensor angle changes.

3.	Microprocessor calculates required degrees of change in head lamp angle.

4.	Sends a proper signal to head lamp leveling device and driving actuator

Operating Condition

1.	Ignition on

2.	Low beam on

3.	On stop : If sensor lever change is 0.3° and above, head lamp is operated after max. 1.5 sec

4.	On driving : If vehicle velocity is over 4km/h (2.48mile/h), velocity change is not over 0.8-1.6km/h (0.5 ~ 1.0mile/h) per second, and loading condition is changed, then head lamp is operated.

Components

Auto head lamp leveling unit

1. Leveling unit & sensor

2. Sensor mounting bracket

3. Sensor linkage

•	Using a Micro-processor, detect the operation lever''s mechanical angle change or speed signal.

•	As an actuator control device of inner control program, mounting on the rear center arm.

Auto Head lamp leveling Unit Schematic Diagrams

Circuit Diagram ...

Auto Head lamp leveling Unit Repair procedures

Inspection 1. Ignition "ON". 2. Turn on the head lamp switch. 3. Check for operation. If the aim of the head lamps changes smoothly when the head lamp leveling switch is turned. 4. If ...

Other Information:

Cluster Ionizer (DATC only) Repair procedures
Inspection 1. Press the MODE switch more than 4 times within 2 seconds while pressing the OFF switch. DisplayFail description00Normal50Cluster ion generator fault * For diagnostic procedur ...

Rear Door Latch Repair procedures
Replacement [Front] 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Disconnect the rear door cable (A). 3. Disconnect the rear door remote controller connector ...

Kia Sedona: Auto Head lamp leveling Unit Description and Operation

Auto Head lamp leveling Unit Schematic Diagrams

Auto Head lamp leveling Unit Repair procedures

Other Information:

Categories