Kia Sedona: Front Seat Belt Pretensioner Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Front Seat Belt / Front Seat Belt Pretensioner Repair procedures

Replacement

When installing the belt, be careful not to damage the pretensioner.

1.	Remove the center pillar upper trim. (Refer to Interior Trim - "Center Pillar Trim")

2.	After loosening the mounting bolts, remove the EFD system (A).

After disconnecting the lock pin, remove the front seat belt pretensioner connector (A), loosen the mounting bolt, and then remove the front seat belt pretensioner (B).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

Install in the reverse order of removal.

•	When ignition switch is turned "ON", check that the indicator lamp turns on for 6 seconds and then off, indicating normal operation of the system.

•	Make sure that the connectors are plugged in properly.

•	Replace any damaged clips.

Front Seat Belt Pretensioner Components and Components Location

Component Location 1. Front seat belt pretensioner ...

Height Adjust Components and Components Location

Component Location 1. Height adjust ...

Other Information:

Troubleshooting
Troubleshooting Trouble SymptomProbable CauseRemedyEngine misfire with abnormal internal lower engine noises.Worn crankshaft bearings.Loose or damaged engine drive plate.Replace the crankshaft an ...

Malfunction Indicator Lamp (MIL)
This warning light illuminates : Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It remains on until the engine is started. When there is a malfunction wit ...

Kia Sedona: Front Seat Belt Pretensioner Repair procedures

Front Seat Belt Pretensioner Components and Components Location

Height Adjust Components and Components Location

Other Information:

Categories