Kia Sedona: Multi Box Repair procedures - Crash Pad - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Multi Box Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Crash Pad / Multi Box Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Remove the multi box hole cap (A), and then loosen the screw to remove the multi box (B).

   
Replace any damaged clips.
Multi Box Components and Components Location
Component Location 1. Multi box ...

Steering Column Shroud Panel Components and Components Location
Component Location 1. Steering column shroud lower panel2. Steering column shroud upper panel ...

Other Information:

Removing the spare tire
Your spare tire is stored underneath your vehicle, directly below the right sliding door. 1. Open the right sliding door and find the plastic hex bolt cover on the floor. 2. Remove the cover. ...

Fuel Pressure Control Valve (FPCV) Repair procedures
Inspection 1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2. Disconnect the fuel pressure regulator valve connector. 3. Measure resistance between the fu ...

Categories

Copyright © www.kisedona.com 2016-2026