Kia Sedona: Glove Box Housing Repair procedures

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Crash Pad / Glove Box Housing Repair procedures

Replacement

Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Disconnect the stopper (B) from the glove box (A).

2.	Disconnect the air damper (A) from the glove box (B).

3.	Using a screwdriver or remover, remove the crash pad side cover [RH] (A).

4.	After loosening the mounting screws and bolts, remove the glove box housing (A).

Install in the reverse order of removal.

•	Make sure that the connectors are connected properly.

•	Replace any damaged clips.

Glove Box Housing Components and Components Location

Component Location 1. Glove box housing ...

Multi Box Components and Components Location

Component Location 1. Multi box ...

Other Information:

Walk-out seat (2nd row seat for SXL package)
To get out from the 3rd row seat, 1. Lift the armrest up , lower the headrests to the lowest position and slide the seat inside. (if necessary). 2. Pull the walk-in strap (1) on the 2nd row seat ...

ESC OFF Switch Repair procedures
Inspection 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. (Refer to Body - "Crash pad lower panel") 3. Remove the crash pa ...

Kia Sedona: Glove Box Housing Repair procedures

Glove Box Housing Components and Components Location

Multi Box Components and Components Location

Other Information:

Categories