Kia Sedona: Crash Pad Lower Panel Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Crash Pad / Crash Pad Lower Panel Repair procedures

Replacement

Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Using a screwdriver or remover, remove the crash pad side cover [LH] (A).

2.	After loosening the mounting screws, remove the crash pad lower panel (A).

3.	Disconnect the diagnosis connector (A) and crash pad under lamp connector (B).

Install in the reverse order of removal.

•	Make sure that the connectors are connected properly.

•	Replace any damaged clips.

Crash Pad Lower Panel Components and Components Location

Component Location 1. Crash pad lower panel ...

Glove Box Housing Components and Components Location

Component Location 1. Glove box housing ...

Other Information:

Front Door Trim Components and Components Location
Component Location 1. Front door trim ...

Evaporator Temperature Sensor Description and Operation
Description The evaporator temperature sensor detects the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by excessive cooling. ...

Kia Sedona: Crash Pad Lower Panel Repair procedures

Crash Pad Lower Panel Components and Components Location

Glove Box Housing Components and Components Location

Other Information:

Categories