Kia Optima Manuals

Kia Sedona: Rear Door Latch Repair procedures - Rear Door - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Rear Door Latch Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Latch Repair procedures

Replacement
[Front]
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Disconnect the rear door cable (A).

3.
Disconnect the rear door remote controller connector (B).

4.
Loosen the bolts and remove the rear door remote controller (A).

5.
Loosen the screw and disconnect the rear door outside handle cable (A).

6.
Loosen the rear door front latch mounting screws.
Tightening torque N.m (kgf.m, lb-ft) :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

7.
Remove the clip and then disconnect the rear door front latch cable (A).

8.
Put a cable (A) into the hole and then remove the rear door front latch (B).

9.
Install in the reverse order of removal.
   
•
Make sure that the connectors are plugged in properly.
•
Replace any damaged clips.
[Rear]
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Remove the rear door trim seal.
3.
Disconnect the rear door latch cable (A).

4.
Loosen the rear door rear latch mounting screw.
Tightening torque N.m (kgf.m, lb-ft) :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

5.
Disconnect the rear door latch connector (A) and then remove the rear door rear latch (B).

6.
Install in the reverse order of removal.
   
•
Make sure that the connectors are plugged in properly.
•
Replace any damaged clips.
Rear Door Latch Components and Components Location
Component Location 1. Rear door front latch2. Rear door rear latch ...

Rear Door Belt Outside Weatherstrip Repair procedures
Replacement 1. Pull down rear door window glass by pressing the power window glass switch. 2. After loosening the mounting screws, remove the rear door belt outside weatherstrip (A). 3. In ...

Other Information:

Battery replacement
The transmitter uses a 3 volt lithium battery which will normally last for several years. When replacement is necessary, use the following procedure. 1. Insert a slim tool into the slot and gentl ...

Components and Components Location
Components 1. Front pillar trim2. Cowl side trim3. Center pillar upper trim4. Center pillar assist trim5. Center pillar lower trim6. Rear pillar trim7. Tailgate fillar trim8. Front door scuff tri ...

Categories

Copyright © www.kisedona.com 2016-2026