Kia Sedona: Rear Door Power Window Regulator Repair procedures - Rear Door - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Rear Door Power Window Regulator Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Power Window Regulator Repair procedures

Replacement
1.
Remove the rear door window glass.
(Refer to Rear Door - "Rear Door Window Glass")
2.
Loosen the mounting nut and remove the rear door power window regulator connector (A).

Tightening torque :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

3.
Remove the rear door power window regulator assembly (A) from the rear door panel.

4.
Install the reverse order of removal.
Rear Door Power Window Regulator Components and Components Location
Component Location 1. Rear door module ...

Rear Door Outside Handle Components and Components Location
Component Location 1. Rear door outside handle ...

Other Information:

Repair procedures
Replacement     Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, an ...

Rail Pressure Sensor (RPS) Repair procedures
Inspection 1. Connect the GDS to the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. Removal 1. Turn the ignition switch OFF and d ...

Categories


Copyright В© www.kisedona.com 2016-2024