Kia Optima Manuals

Kia Sedona: Rear Door Window Glass Repair procedures - Rear Door - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Rear Door Window Glass Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Window Glass Repair procedures

Replacement
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Remove the rear door belt inside weatherstrip (A).

3.
Pull down rear door window glass by pressing the power window glass switch.
4.
After loosening the mounting screws, remove the rear door belt outside weatherstrip (A).

5.
Completely loosen the rear door channel mounting bolt and loosen the nuts as much as possible until they are just enough to hold the rear door panel.
6.
Slightly push the rear door channel in the direction of the arrow in the illustration below.

7.
Remove the rear door window glass mounting hole plug (A).

   
Be careful not to drop the glass and/or scratch the glass surface.
   
•
Use the door switch to align the mounting hole/bolt with the hole in the door.
•
If unable to operate the window motor, remove the motor and align the hole by hand.
8.
Carefully adjust the rear door window glass (A) until you can see the bolt, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

9.
Install in the reverse order of removal.
   
•
Roll the glass up and down to see if it moves freely without binding.
•
Adjust glass position as needed.
•
Make sure that the door locks and opens properly.
•
Replace any damaged clips.
Rear Door Window Glass Components and Components Location
Component Location 1. Rear door window glass ...

Rear Door Power Window Regulator Components and Components Location
Component Location 1. Rear door module ...

Other Information:

Temperature Control Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the cool position when 1 ...

Checking the power steering fluid level
With the vehicle on level ground, check the fluid level in the power steering reservoir periodically. The fluid should be between MAX and MIN marks on the side of the reservoir at the normal tem ...

Categories

Copyright © www.kisedona.com 2016-2026