Kia Sedona: Tail Gate Assembly Repair procedures| Replacement |
Wear gloves to protect hands from injury. |
When removing and installing the tail gate, work in a group of two or more. |
| 1. |
Remove the tail gate upper trim.
(Refer to Tail Gate - "Tail Gate Trim") |
| 2. |
Remove the tail gate side trim.
(Refer to Tail Gate - "Tail Gate Trim") |
| 3. |
Remove the tail gate trim.
(Refer to Tail Gate - "Tail Gate Trim") |
| 4. |
Disconnect the washer nozzle hose (A) and high mounted stop lamp connector (B).
|
| 5. |
Disconnect the connectors and tail gate wiring harness (A). |
| 6. |
Loosen the ground bolts (B). |
| 7. |
After loosening the mounting bolts, remove the tail gate assembly (C).
|
| 8. |
Remove the mounting clip (B) and then remove the tail gate lifter (A).
|
| 9. |
Install in the reverse order of removal.
|
Tail Gate Assembly Components and Components Location
Tail Gate Trim Components and Components LocationFloor mat anchor (s)
When using a floor mat on the front floor carpet, make sure it attaches to the
floor mat anchor(s) in your vehicle. This keeps the floor mat from sliding forward.
The following must be observed w ...
Ignition switch position
LOCK
The steering wheel locks to protect against theft (if equipped). The ignition
key can be removed only in the LOCK position.
ACC (Accessory)
The steering wheel is unlocked and electrical ac ...