Removal |
Parking brake pedal Type |
1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash pad lower panel") |
3. |
Remove the parking brake cable mounting nut (A) and bolts(B). |
4. |
Remove the parking brake cable adjusting nut(A) and the fixing clip(B), and then remove the parking brake pedal. |
5. |
Remove the floor console.
(Refer to Body - "Floor console") |
6. |
Loosen the adjusting nut (A) and the parking brake cables (B). |
7. |
Raise the vehicle, and make sure that it is securely supported. |
8. |
Remove the rear wheel & tire. |
9. |
Remove the parking brake cable (A). |
10. |
Loosen the parking brake cable bracket bolts and remove the rear parking brake cable. |
11. |
Install in the reverse order of removal. |
To resume cruise control set speed
If any method other than the CRUISE button was used to cancel cruising speed
and the system is still activated, the cruising speed will automatically resume
when you move the lever up/down (to R ...
Transaxle Control Module (TCM) Repair procedures
Inspection
1.
TCM ground circuit test: Measure resistance between TCM and
chassis ground using the backside of TCM harness connector as TCM side check point.
Specification: Below 1Ω
...