Kia Sedona: Rear Coil Spring Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Suspension System / Rear Suspension System / Rear Coil Spring Repair procedures

Removal

Remove the rear wheel and tire (A) from rear hub.

Tightening torque :

88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)

Be careful not to damage the hub bolts when removing the rear wheel and tire (A).

Support the jack and then remove the carrier bolt (B).

Tightening torque:

156.9 ~ 176.5N.m (16.0 ~ 18.0kgf.m, 115.7 ~ 130.2lb-ft)

3.	Remove the spring (A), the upper pad (B) and the lower pad (C).

4.	Install in the reverse order of removal.

5.	Check the rear alignment. (Refer to Rear Suspension System - "Rear Alignment")

Inspection

1.	Check the spring for distortion, aging or damage.

2.	Check the spring upper pad and lower pad for aging or damage.

Rear Lower Arm Repair procedures

Removal 1. Remove the rear wheel and tire (A) from rear hub. Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage ...

Trailing Arm Repair procedures

Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage ...

Other Information:

Engine Oil and Filter Repair procedures
Inspection Engine Oil Level Be sure that the vehicle is on level ground. 1. Warm up and stop the engine, and then wait for 5 minutes. 2. Turn the engine off an ...

240,000 km (150,000 miles) or 120 months
❑ Rotate tire ❑ Inspect battery condition ❑ Inspect vacuum hose ❑ Inspect air conditioning refrigerant ❑ Inspect brake hoses and lines ❑ Inspect drive sh ...

Kia Sedona: Rear Coil Spring Repair procedures

Rear Lower Arm Repair procedures

Trailing Arm Repair procedures

Other Information:

Categories