Kia Optima Manuals

Kia Sedona: Input Speed Sensor Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sedona YP Service ManualKia Sedona: Input Speed Sensor Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Input Speed Sensor Repair procedures

Inspection
1.
Turn ignition switch OFF.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the solenoid valve connector (A).

4.
Measure the resistance between power terminal (14) and signal terminal (8).
Specification : Approx. 0.88 MΩ

Removal
1.
Remove the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
2.
Disconnect the input & output speed sensor connector (A).
3.
Remove the input & output speed sensor (B) after loosening the bolts.
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Installation
1.
Install in the reverse order of removal.
   
•
Refill the automatic transaxle with fluid.
(Refer to Hydraulic System - "Fluid")
•
Confirm there is no fluid leak on connections after repairs.
Input Speed Sensor Schematic Diagrams
Circuit Diagram ...

Output Speed Sensor Specifications
Specification Item SpecificationTypeHall effect sensorOperation condition (°C)°F(-40 ~ 150)-40 ~ 302Output voltage (V)High: 1.18 ~ 1.68Low: 0.59 ~ 0.84 ...

Other Information:

Exterior overview
Front view 1. Hood 2. Head lamp 3. Fog lamp 4. Wheel and tire 5. Outside rearview mirror 6. Sunroof 7. Front windshield wiper blades 8. Windows 9. Parking assist system Rear view 10. Do ...

Radiator Repair procedures
Removal and Installation 1. Disconnect the battery negative terminal. 2. Remove the engine room under cover. (Refer to Engine And Transaxle Assembly - "Engine Room Under Cover") 3. Drain ...

Categories

Copyright © www.kisedona.com 2016-2026