Kia Sedona: Repair procedures
Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Blind Spot Detection System / Repair procedures
| Diagnosis With GDS |
| 1. |
BSD system defects can be quickly diagnosed by the GDS. GDS
quickly operates actuator to monitor input/output values and to
self-diagnose. |
| 2. |
Connect the cable of GDS to the data link connector on driver side crash pad lower panel, and turn the power on GDS. |
| 3. |
Select the vehicle model and then BSD system. |
| 4. |
Select "Current Data", if you want to check current data of BSD system.
|
| 5. |
If you want to check each module operation forcefully, select "Actuation test".
|
Description and Operation
Description
BSD system uses two magnetic wave radar sensors attached on
the rear panel to measure the distance from the following vehicles and
provide sensing and (visual and auditory) alarms f ...
Other Information:
Idler Repair procedures
Removal and Installation
1.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
2.
Remove the drive belt idler (A).
Tightening torque :
53.9 ~ 57.9 N.m (5.5 ~ 5.9 kgf.m, 39.8 ...
Non-operational conditions of rear parking assist system
The rear parking assist system may not operate properly when :
1. Moisture is frozen to the sensor. (It will operate normally when the moisture
has been cleared.)
2. The sensor is covered with for ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2026 Owners Manual
- Kia Sedona YP 2014-2026 Service Manual
Copyright © www.kisedona.com 2016-2026