Kia Sedona: Rear Washer Motor Repair procedures - Rear Wiper/Washer - Body Electrical System - Kia Sedona YP Service ManualKia Sedona: Rear Washer Motor Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Rear Wiper/Washer / Rear Washer Motor Repair procedures

Inspection
1.
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
   
Before filling the reservoir tank with water, check the filter for any foreign material or contamination. If necessary, clean the filter in the pump motor.
2.
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover")
3.
Connect positive (+) and negative (-) battery cables to terminals 3 and 2 respectively to see that the washer motor runs and water is pumped.
4.
Check that the motor operates normally.
Replace the motor if it operates abnormally.
No.
Description
1
Rear washer (+)
2
Ground

Rear Washer Switch Repair procedures
Inspection 1. Check for continuity between the terminals while operating the wiper and washer switch. If it is not in normal condition, replace wiper and wiper switch. Rear Wiper Switch Rear ...

Seat Electrical
...

Other Information:

Air bag warning label
Air bag warning labels, some required by the Canada Motor Vehicle Safety Standards (CMVSS), are attached to the sunvisor to alert the driver and passengers of potential risks of the air bag sy ...

CVVT (Continuous Variable Valve Timing) System Description and Operation
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by ...

Categories

Copyright © www.kisedona.com 2016-2026