Kia Optima Manuals

Kia Sedona: Rear Shock Absorber Repair procedures - Rear Suspension System - Suspension System - Kia Sedona YP Service ManualKia Sedona: Rear Shock Absorber Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Suspension System / Rear Suspension System / Rear Shock Absorber Repair procedures

Removal
1.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
   
Be careful not to damage the hub bolts when removing the rear wheel and tire (A).

2.
Loosen the shock absorber bolt (A) and nut (B).
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)

3.
After loosening the nut (A), remove the rear shock absorber.
Tightening torque:
137.3 ~ 156.9 N.m (14.0 ~ 16.0 kgf.m, 101.3 ~ 115.7 lb-ft)

4.
Install in the reverse order of removal.
5.
Check the rear alignment.
(Refer to Rear Suspension System - "Rear Alignment")
Inspection
1.
Check the rubber parts for damage or deterioration.
2.
Check the shock absorber for abnormal resistance or unusual sounds.
Components and Components Location
Components 1. Rear upper arm2. Rear stabilizer bar3. Rear lower arm4. Rear assist arm5. Rear shock absorber6. Rear cross member7. Trailing arm ...

Rear Upper Arm Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)     Be careful not to damage ...

Other Information:

Rheostat Schematic Diagrams
Circuit Diagram ...

Vehicle recognition
Some vehicles ahead in your lane cannot be recognized by the sensor as follows: - Narrow vehicles such as motorcycles or bicycles - Vehicles offset to one side - Slow-moving vehicles or suddendec ...

Categories

Copyright © www.kisedona.com 2016-2026