Kia Optima Manuals

Kia Sedona: Rear Heater Unit Repair procedures - Rear Heater - Heating,Ventilation And Air Conditioning - Kia Sedona YP Service ManualKia Sedona: Rear Heater Unit Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Rear Heater / Rear Heater Unit Repair procedures

Replacement
1.
Disconnect the battery negative terminal.
2.
Recover the refrigerant with a recovery/ recycling/ charging station.
3.
When the engine is cool, drain the engine coolant from the radiator.
(Refer to Engine Mechanical System - “Coolant”)
4.
Remove the luggage side trim [RH].
(Refer to Body - "Luggage Side Trim")
5.
Remove the rear heater duct (A) after loosening the bolts.

6.
Disconnect the rear refrigerant line (A) after loosening the nut.
Tightening torque : 6.9 ~ 10.8 N.m ( 0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 Ib-ft)

   
•
Plug or cap the lines immediately after disconnecting them to avoid moisture and dust contamination.
•
When installing, replace with a new O-ring (B).
7.
Disconnect the rear heater main connector (A).

8.
Disconnect the rear heater hose (A) from rear heater core.

   
Engine coolant will run out when the hoses are disconnected; drain it into a clean drip pan. Be sure not to let coolant spill on electrical parts or painted surfaces. If any coolant spills, rinse it off immediately.
9.
Remove the rear heater & A/C unit (A) after loosening the nuts.

10.
Install in the reverse order of removal.
Rear Heater Unit Components and Components Location
Components Location 1. Rear Heater & A/C Unit Components 1. Rear Liquid & Suction Pipe2. Rear Expansion Valve3. Rear Evaporator Core4. Rear Blower motor Assembly5. Rear Heater Core ...

Rear Heater Core Repair procedures
Replacement 1. Disconnect the battery negative terminal. 2. When the engine is cool, drain the engine coolant from the radiator. (Refer to Engine Mechanical System - “Coolant”) 3. Rem ...

Other Information:

AUX jack Components and Components Location
Components ...

Starter Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2. Remove the engine room under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover" ...

Categories

Copyright © www.kisedona.com 2016-2026