Kia Sedona: Rear Door Belt Inside Weatherstrip Repair procedures - Rear Door - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Rear Door Belt Inside Weatherstrip Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Belt Inside Weatherstrip Repair procedures

Replacement
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Remove the rear door belt inside weatherstrip (A).

3.
Install in the reverse order of removal.
   
Replace any damaged clips.
Rear Door Belt Outside Weatherstrip Repair procedures
Replacement 1. Pull down rear door window glass by pressing the power window glass switch. 2. After loosening the mounting screws, remove the rear door belt outside weatherstrip (A). 3. In ...

Rear Door Side Weatherstrip Repair procedures
Replacement 1. Remove the clips (C) and remove the rear door side weatherstrip (A).     Butyl tape (B) and mounting clips (C) securely seated. 2. Install in the rev ...

Other Information:

Knock Sensor (KS) Repair procedures
Removal [Bank 1] 1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2. Remove the intake manifold. (Refer to Engine Mechanical System - "Intake Manifold") ...

Compression Test
Compression Pressure Inspection     If there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure. 1. Warm up the engine t ...

Categories

Copyright © www.kisedona.com 2016-2026