Your vehicle may require the ignition switch to be turned to the ACC position for programming and/or operation of HomeLink. It is also recommended that a new battery be replaced in the hand-held transmitter of the device being programmed to HomeLink for quicker training and accurate transmission of the radiofrequency.
Follow these steps to train your HomeLink mirror:
1. When programming the buttons for the first time, press and hold the left and
center buttons (,
)
simultaneously until the indicator light begins to flash after approximately 20
seconds. (This procedure erases the factory-set default codes. Do not perform this
step when programming the additional HomeLink buttons.)
✽ NOTICE
For non rolling code garage door openers, follow steps 2 - 3.
For rolling code garage door openers, follow steps 2 - 6.
For Canadian Programming, please follow the Canadian Programming section.
For help with determining whether your garage door opener is nonrolling code
or rolling code, please refer to the garage door openers owner SS-B Solenoid Valve(ON/OFF) Description and Operation Troubleshooting
To operate the electric rearview mirror
Press the I button (1) to turn the automatic- dimming function on. The mirror
indicator light will illuminate.
Press the O button (2) to turn the automati ...
Electrochromic mirror with HomeLink system
To train a garage door opener (or other rolling code equipped devices) with the
rolling code feature, follow these instructions after completing the ...
Rolling code programming
Other Information:
Description
•
SS-B solenoid valve is ON/OFF type.
•
When TCM supplies power to solenoid valve, speed range is changed by operating the solenoid valve.
SS-B Solenoid Valve op ...
Troubleshooting
SymptomSuspect areaEngine will not start or stuggle to startVapor hose damaged or disconnectedEngine struggles to startMalfunction of the Purge Control Solenoid ValveRough idle or ...