The auto lock mode will help prevent the normal movement of the child in the vehicle from causing the seat belt to loosen and compromise the child restraint system. To secure a child restraint system, use the following procedure.
To install a child restraint system on the outboard or center rear seats, do the following :
1. Place the child restraint system in the seat and route the lap/shoulder belt around or through the restraint, following the restraint manufacturer
Manifold Absolute Pressure Sensor (MAPS) Repair procedures
Inspection
1.
Connect the GDS to the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Pressure [kPa (kgf/cmВІ, psi)]Output Voltage (V) [Ref=5V]20.0 (0 ...
Intake Manifold Repair procedures
Removal and Installation
1.
Remove the engine cover.
(Refer to Engine and Transaxle Assembly - "Engine Cover")
2.
Remove the engine room under cover.
(Refer to Engine and Transaxle Assembly ...