Kia Optima Manuals

Kia Sedona: Oil Pump Repair procedures - Lubrication System - Engine Mechanical System - Kia Sedona YP Service ManualKia Sedona: Oil Pump Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Mechanical System / Lubrication System / Oil Pump Repair procedures

Removal and Installation
1.
Drain engine oil.
(Refer to Lubrication System - "Engine Oil")
2.
Remove the engine room under cover.
(Refer to Engine And Transaxle Assembly - "Engine Room Under Cover")
3.
Remove the lower oil pan.
(Refer to Lubrication System - "Oil Pan")
4.
Remove the oil pump chain cover (A).
Tightening torque :
9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)

5.
Remove the bolt (A) and then separate the chain with sprocket from the oil pump.
Tightening torque :
18.6 ~ 21.6N.m (1.9 ~ 2.2kgf.m, 13.7 ~ 15.9lb-ft)

6.
Remove the oil pump (A).
Tightening torque :
20.6 ~ 22.6N.m (2.1 ~ 2.3kgf.m, 15.2 ~ 16.6lb-ft)

   
When installing, use a new O-ring.
7.
Install in the reverse order of removal.
8.
After assembly, wait for at least 30 minutes before filling the engine with oil.
Oil Pump Components and Components Location
Components 1. Oil pump2. O-ring3. Oil pump sprocket4. Oil pump chain cover ...

Oil Pressure Switch Components and Components Location
Components 1. Oil cover2. Oil cover gasket3. Oil pressure switch ...

Other Information:

DRIVE mode
The drive mode may be selected according to the driver ...

Rear Temperature Control Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the actuator operates to the recirculation position when 12V is connect ...

Categories

Copyright © www.kisedona.com 2016-2026