Kia Sedona: Drive Belt Tensioner Repair procedures - Timing System - Engine Mechanical System - Kia Sedona YP Service ManualKia Sedona: Drive Belt Tensioner Repair procedures

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Engine Mechanical System / Timing System / Drive Belt Tensioner Repair procedures

Removal and Installation
1.
Remove the drive belt idler.
(Refer to Timing System - "Idler")
2.
Remove the drive belt auto tensioner (A).

Tightening torque
Bolt (B) :
81.4 ~ 85.3 N.m (8.3 ~ 8.7 kgf.m, 60.0 ~ 62.9 lb-ft)
Bolt (C) :
17.7 ~ 21.6 N.m (1.8 ~ 2.2 kgf.m, 13.0 ~ 15.9 lb-ft)

3.
Install in the reverse order of removal.
Inspection
Check the belt tensioner for excessive dust, crack, and damage. Replace if necessary.
Drive Belt Tensioner Components and Components Location
Components 1. Drive belt tensioner ...

Crankshaft Damper Pulley Components and Components Location
Components 1. Crankshaft damper pulley ...

Other Information:

Power sliding door operation
Push the corresponding main control button on the overhead console to open or close the power sliding door. However, the power sliding door will not open with the main control button when ...

1. Crankcase emission control system
The positive crankcase ventilation system is employed to prevent air pollution caused by blow-by gases being emitted from the crankcase. This system supplies fresh filtered air to the crankcase th ...

Categories


Copyright В© www.kisedona.com 2016-2025