Check the battery voltage and status using the battery tester.
Battery Terminal
1.
Move back and forth to check that the battery terminals (A) are loose or corroded.If the terminals are corroded, clean them.
If battery positive connection is loose, disconnect
ground(GND) cable first before attempting to remove or tighten plus
connection, to prevent personal injury.
2.
If the battery clamp on battery positive (+) terminal is not seated securely:
(1)
Turn ignition switch OFF and disconnect the battery negative (-) terminal.
(2)
Tighten battery clamp (A) on battery positive (+) terminal
Battery positive (+) terminal:
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)
3.
If the battery clamp on battery negative (-) terminal is not seated securely:
(1)
Tighten battery clamp (A) on battery negative (-) terminal.
Battery negative (-) terminal:
4.0 ~ 6.0 N.m (0.4 ~ 0.6 kgf.m, 3.0 ~ 4.4 lb-ft)
Battery Condition
Check the battery for damage or deformation. If severe damage, deformation or leakage is found, replace the battery.
Inspection
1.
Remove the air cleaner element.
2.
Check that the air filter is excessively dirty.
If the air filter is excessively dirty, replace the air cleaner element.
3.
If the air cl ...
Inspection
Radiator hoses
1.
Check radiator hoses for the following
(1)
Improper attachment
(2)
Leaks
(3)
Cracks
(4)
Damage
(5)
Loose connections
(6)
Chafing
(7)
Deterio ...
Other Information:
Transaxle Control Module (TCM) Repair procedures
Inspection
1.
TCM ground circuit test: Measure resistance between TCM and
chassis ground using the backside of TCM harness connector as TCM side check point.
Specification: Below 1Ω
...
Description and Operation
Description
The immobilizer system will disable the vehicle unless the
proper ignition key is used. In addition to the currently available
anti-theft systems such as car alarms, the immobilizer ...