Pressing or pulling up the power window switch momentarily to the second detent position (6) completely lowers or raises the window even when the switch is released. To stop the window at the desired position while the window is in operation, pull up or press down and release the switch.
If the power window does not operate normally, the automatic power window system must be reset as follows:
1. Turn the ignition switch to the ON position.
2. Close the driver's and passenger's window and continue pulling up the driver
Exhaust Manifold Repair procedures
Removal and Installation
[LH Exhaust Manifold]
1.
Disconnect the battery negative terminal.
2.
Remove the engine cover.
(Refer to Engine and Transaxle Assembly - "Engine Cover")
3.
Remov ...
Cooling Fan Components and Components Location
Components
1. Cooling fan2. Fan motor3. Cooling fan shroud4. Cooling fan resistor
...