Kia Sedona: 26 Brake Control Solenoid Valve(26/B_VFS) Repair procedures
Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / 26 Brake Control Solenoid Valve(26/B_VFS) Repair procedures
| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery") |
| 3. |
Disconnect the solenoid valve connector (A).
|
| 4. |
Measure the resistance between power terminal (5) and signal terminal (11).
|
| Replacement |
If a solenoid valve of VFS type needs to be replaced, the
valve body assembly should be replaced and the oil pressure should be
adjusted. If the solenoid valve is replaced individually, it is not
possible to adjust the oil pressure without additional equipment, and if
the oil pressure adjustment procedure is not performed, a shift shock
or delay may occur. |
| 1. |
Replace the valve body assembly.
(Refer to Hydraulic System - "Valve Body") |
26 Brake Control Solenoid Valve(26/B_VFS) Schematic Diagrams
Circuit Diagram
...
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Specifications
Specification
Item SpecificationControl typeN/H (Normal High)"Control pressure kpa (kgf/cm², psi)""500.14 ~ 9.81 (5.1 ~ 0.1, 72.54 ~ 1.42)"Current value (mA)50 ~ 850Coil resistance(Ω)5.1 ± 0. ...
Other Information:
Yaw-rate and G Sensor Repair procedures
Removal
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty seconds before beginning work.
3.
Remove the floor console.
(Re ...
Instrument Cluster Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia upper panel.
(Refer to Body - "Center Fascia Panel")
3.
Remove the instrument cluster (A) after loosen ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2026 Owners Manual
- Kia Sedona YP 2014-2026 Service Manual
Copyright © www.kisedona.com 2016-2026