Kia Sedona: Blower Resistor (Manual) Repair procedures
Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Blower / Blower Resistor (Manual) Repair procedures
| Inspection |
| 1. |
Measure the resistance between the terminals. |
| 2. |
If the measured resistance is not within specification, the blower resistor must be replaced (after removing the resistor).
|
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the glove box housing.
(Refer to Body - "Glove Box Housing") |
| 3. |
Disconnect the connector (A) and then remove the blower resistor (B) after loosening the mounting screws.
|
| 4. |
Install in the reverse order of removal. |
Blower Motor Repair procedures
Inspection
1.
Connect the battery voltage and check the blower motor rotation.
2.
If the blower motor does not operate well, substitute with a known-good blower motor and check for proper oper ...
Field Effect Transistor (DATC) Repair procedures
Inspection
1.
Turn the ignition switch ON.
2.
Manually operate the control switch and measure the voltage of the blower motor.
3.
Operate the control switch to raise the voltage up to high ...
Other Information:
Interior light bulb replacement
Map lamp
Room lamp
Glove box lamp
Luggage lamp
Vanity mirror lamp ...
Exhaust Manifold Repair procedures
Removal and Installation
[LH Exhaust Manifold]
1.
Disconnect the battery negative terminal.
2.
Remove the engine cover.
(Refer to Engine and Transaxle Assembly - "Engine Cover")
3.
Remov ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2026 Owners Manual
- Kia Sedona YP 2014-2026 Service Manual
Copyright © www.kisedona.com 2016-2026