Kia Optima Manuals

Kia Sedona: Field Effect Transistor (DATC) Repair procedures - Blower - Heating,Ventilation And Air Conditioning - Kia Sedona YP Service ManualKia Sedona: Field Effect Transistor (DATC) Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Blower / Field Effect Transistor (DATC) Repair procedures

Inspection
1.
Turn the ignition switch ON.
2.
Manually operate the control switch and measure the voltage of the blower motor.
3.
Operate the control switch to raise the voltage up to high speed.

Specification
Fan Speed (Manual)
Motor Voltage (V)
1
3.8
2
4.6
3
5.9
4
7.2
5
8.3
6
9.5
7
11.3
8
Battery

4.
If the measured voltage is not within specification, substitute with a known-good field effect transistor and check for proper operation.
5.
Replace the field effect transistor if it is proved that there is a problem with it.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
3.
Disconnect the connector (A) and then remove the field effect transistor (B) after loosening the mounting screws.

4.
Install in the reverse order of removal.
Blower Resistor (Manual) Repair procedures
Inspection 1. Measure the resistance between the terminals. 2. If the measured resistance is not within specification, the blower resistor must be replaced (after removing the resistor). Repl ...

Climate Control Air Filter Description and Operation
Description The climate control air filter is located in the blower unit. It eliminates foreign materials and odor. The particle filter performs a role as an odor filter as well as a conventio ...

Other Information:

Components and Components Location
Component Location 1. Hands free call switch2. Mic3. Front left speaker4. Front right speaker5. Audio head unit & AVN head unit (hands free control) ※ There is no hands free jack. This s ...

Inhibitor Switch Repair procedures
Inspection Power Circuit Inspection 1. Disconnect the Inhibitor switch connector. 2. Ignition KEY "ON"" & Engine "OFF".. 3. Measure voltage between supplied power and ground at inhi ...

Categories

Copyright © www.kisedona.com 2016-2026